[ESP-ENG] Elaborando un porta llavero. | Making a key holder.

avatar

PORTADA.png

Hola mis amigos de Hive, feliz de compartir nuevamente con ustedes, hoy les voy a mostrar como elaborar un lindo porta llavero, hecho con cartón, es fácil de elaborar, y es muy útil en nuestra casa, para así tener siempre a la mano nuestras llaves. A continuación el paso a paso.

Hello my friends from Hive, happy to share with you again, today I am going to show you how to make a nice key holder, made with cardboard, it is easy to make, and it is very useful in our home, so we can always have our keys at hand. Here is the step by step.


MATERIALES.png

Español

Materiales:

  • Un pedazo de cartón.
  • (1) hoja blanca.
  • Tijera.
  • Lapiz.
  • (1) barra de silicon.
  • Pincel.
  • Regla.
  • Tempera roja.
  • Cuchillo.
  • Un pedacito de trenza.

English

Materials:

  • Piece of cardboard.
  • (1) white sheet of paper.
  • Scissors.
  • pencil.
  • (1) Silicone stick.
  • Paintbrush.
  • Ruler.
  • Red tempera.
  • Knife.
  • A piece of braid.

SEPARADOR.png

1.png

Español

Paso 1:

  • Primeramente en la hoja blanca dibujamos la llave con una medida de (22cm) de largo, la recortamos y la usamos como patrón marcando con el lápiz en el cartón, luego con el cuchillo recortamos la llave, del mismo modo hacemos otra igual y la pegamos una encima de la otra para que quede mas fuerte.

English

Step 1:

  • First we draw the key on the white sheet with a measure of (22cm) long, we cut it out and use it as a pattern marking it with the pencil on the cardboard, then with the knife we cut out the key, in the same way we make another one and glue it one on top of the other to make it stronger.

SEPARADOR.png

2.png

Español

Paso 2:

  • Ahora continuamos dibujando con la tempera roja, todo el borde de la llave y un círculo en la parte redonda, después cortamos (6) pedacitos de cartón, (3) de (2cm) y los otros (3) de (1cm), luego lo pegamos con silicon como lo muestra la foto, y procedemos a pegarlo en la llave, luego cortamos (2) pedacitos de trenza, lo pegamos en la parte de atrás del llavero donde sera colgado a la pared.

English

Step 2:

  • Now we continue drawing with the red tempera, all the edge of the key and a circle in the round part, then we cut (6) pieces of cardboard, (3) of (2cm) and the other (3) of (1cm), then we glue it with silicon as shown in the photo, and proceed to paste it on the key, then we cut (2) pieces of braid, we glue it on the back of the keychain where it will be hung to the wall.

SEPARADOR.png

Espero les guste mi resultado final, es muy sencillo de elaborar.

I hope you like my final result, it is very easy to make.

Diseño sin título (1).png

Diseño sin título (3).png

Diseño sin título.png

Diseño sin título (2).png

SEPARADOR.png

Todas las fotos son de mi autoria y editadas con canva.

All photos are my own and edited with canva.

SEPARADOR.png

erur4ur5u.jpg



0
0
0.000
0 comments