[ESP-ENG] Les presento mi ventilador Hive de 3 velocidades - Introducing my Hive 3-speed fan

avatar

Hola amigos de Hive, cómo están? Hoy les enseñare como hacer un ventilador de 3 velocidades con un motor de aire acondicionado. Les cuento: este era un aire dañado que tenía en casa, se dañó el compresor y no tenía dinero para repararlo, donde vivo hace mucho calor, entonces se me ocurrió la idea de crear un ventilador. Esta es una buena idea si tienes un aire acondicionado dañado y quieres darle un buen uso sin gastar dinero.

Hello Hive friends, how are you? Today I will show you how to make a 3-speed fan with an air conditioner motor. I tell you: this was a damaged air I had at home, the compressor was damaged and had no money to repair it, where I live is very hot, then I came up with the idea of creating a fan. This is a good idea if you have a damaged air conditioner and want to give it a good use without spending money.

IMG_20210506_231319.jpg


IMG_20210506_162442.jpg

Materiales que se utilizaron para la creación del ventilador
-Aspa de ventilador para aire acondicionado
-Taladro
-Silla
-4 tornillos de perforación de 10mm
-Capacitador para aire acondicionado
-Anime
-Cuchillo
-Destornillador de estría
-Llave de 10mm
-Dado de 10mm
-Llave ½
-Motor de aire acondicionado
-Suiche selector de 3 velocidades.

Materials used for the creation of the fan
-Fan blade for air conditioning
-Drill
-Chair
-4 10 mm drill screws
-Air conditioning capacitor
-Anime
-Knife
-Spline screwdriver
-10mm wrench
-10mm socket
-½" wrench
-Air conditioning motor
3-speed selector switch.


IMG_20210506_153826.jpg

IMG_20210506_160343~2.jpg

IMG_20210506_160925.jpg

IMG_20210506_161318.jpg

Paso 1: primero sacamos el motor del ventilador del aire acondicionado, luego marcamos con el motor la medida para taladrar el motor a la silla, taladramos cuidadosamente.

Step 1: first we take out the air conditioner fan motor, then we mark with the motor the measure to drill the motor to the chair, we drill carefully.


IMG_20210506_161709.jpg

IMG_20210506_161750.jpg

IMG_20210506_163021.jpg

IMG_20210506_163332.jpg

IMG_20210506_163423.jpg

IMG_20210506_175809.jpg

Paso 2: Cortamos el anime en 2, después procedemos a taladrar cuidadosamente un orificio en medio de cada anime, para evitar la vibración y nivelar el motor, colocamos el anime entre el motor y la silla.

Step 2: Cut the anime in 2, then proceed to carefully drill a hole in the middle of each anime, to avoid vibration and level the motor, place the anime between the motor and the chair.


IMG_20210506_180930.jpg

IMG_20210506_181843.jpg

IMG_20210506_213426.jpg

IMG_20210506_214031.jpg

IMG_20210506_220533.jpg

IMG_20210506_221640.jpg

Paso 3: Diseñar, pintar y cortar el logo hive y pegarlo al ventilador.

Step 3: Design, paint and cut out the hive logo and attach it to the fan.


Este es mi resultado final, espero que les haya gustado.

This is my final result, I hope you liked it.

IMG_20210506_231319.jpg




0
0
0.000
0 comments