My Technology Trail (@mytechtrail) - CTPtalk

My Technology Trail

mytechnologytrail.blogspot.ca

Ontario Canada

Projects I am working on, Raspberry Pi, Python and Ham Radio.

@mytechtrail 63

6 months ago

Kit build - QRPGuys Digital FSK Transceiver III Well I had last week off and finally got around to building the QRPGuys Digital FSK Transceiver III. This kit is a digital Ham Radio transceiver that is capable of outputting…

213

0

8.587 CTP

@mytechtrail 63

6 months ago

Antenna Tuner kit build Here is another QRPGuys kit. I built this 10-40M antenna tuner kit. The following is the parts laid out for inventory before the build. Here I soldered the PCB angle pieces to mount

110

0

5.369 CTP

@mytechtrail 63

6 months ago

Next kit build, QRPGuys power/SWR/dummy load My next Ham Radio kit, another QRPGuys.com The following is my workbench setup for the kit build. This next picture is all the kit parts laid out to do an inventory. ![1-check-pa

78

0

7.778 CTP

@mytechtrail 63

6 months ago

Improved Ham Shack layout New layout of my Ham Shack. So after building the new power pole distribution board it was time to get the Ham Shack layout redone. As you can see I put in a short shelf to have

90

0

51.803 CTP

@mytechtrail 63

6 months ago

Second power pole distribution board I ordered and built a second power pole distribution board. I will be using this one for my reorganized Ham Shack. I have connected this one directly to a 25Amp power supply. In the

95

0

51.046 CTP

@mytechtrail 63

9 months ago

My first Ham Radio Fox Hunt That is where one Ham operator (fox) goes to a fixed location and starts broadcasting, for our beginners group he was just talking on a specified frequency. I was teamed up with…

135

0

41.872 CTP

@mytechtrail 63

10 months ago

Putting first kit build to use Been a couple days since I finished the first kit, in the this post I will show how I am using the 6 position dc power distribution kit I finished last week. First I replaced the…

127

0

55.022 CTP

@mytechtrail 63

10 months ago

First Contact I was blessed with a gift on Sunday. A local Ham Radio operator passed away and wished that his radio go to a deserving Ham. My elmer VE3GSO was in charge of dealing with the Ham…

109

0

66.690 CTP

@mytechtrail 63

10 months ago

Kit build session 2 Here are the pictures of my second building session on the 6-position-dc-power-distribution-kit This is a picture with my soldering iron, I have replaced the small tip with a…

174

0

14.472 CTP

@mytechtrail 63

10 months ago

Kit build session 1 Here are the pictures of my first building session on the 6-position-dc-power-distribution-kit: Here is the kit laid out showing all of the part ready for assembly: ![6posdist-step1.jpg](

196

0

76.930 CTP