Kit build session 1

Here are the pictures of my first building session on the 6-position-dc-power-distribution-kit:

Here is the kit laid out showing all of the part ready for assembly:
6posdist-step1.jpg

This picture I am have cut up the wire into 14 pieces to solder into the Anderson Power Pole tabs. It also shows the printed circuit board bottom with the fuse holders inserted waiting to be soldered into the board:

6posdist-step2.jpg

In this picture I have finished soldering the wire pieces into the tabs ready for insertion into the connectors. The fuse holders have been soldered into the board as well:

6posdist-step3.jpg

This picture is the tabs inserted into the Anderson Power Pole connectors ready to be soldered int the printed circuit board:
6posdist-step4.jpg

Enough for my first build session, more tomorrow.

Posted with STEMGeeks



0
0
0.000
3 comments
avatar

So this way you are trying to assemble a kit for dc power distribution? Looks like an interesting way to create.

0
0
0.000
avatar

It is fairly common in the Ham Radio community to use Anderson Power Pole connectors to power every thing. This makes it easy to connect my large 20Amp 12Volt power supply to various devices on the bench I use for Ham Radio.

0
0
0.000